Mustang GT350 Forums banner
1 - 20 of 32 Posts

·
Registered
Joined
·
41 Posts
Discussion Starter · #4 ·
ANNOUNCEMENT from Craig’s Custom Mustang Brackets!!

The new 2015-2016 Shelby GT350 Front License Plate Bracket is available for purchase on our website and will start shipping on 13 Jan 2016. You can use this direct link to order. Thank you and we look forward to your business!

2015-2016 Mustang Bracket | Craig's Custom Mustang Brackets

Respectfully,

Craig Broussard
757-636-2445
 

·
Registered
Joined
·
186 Posts
ANNOUNCEMENT from Craig’s Custom Mustang Brackets!!

The new 2015-2016 Shelby GT350 Front License Plate Bracket is available for purchase on our website and will start shipping on 13 Jan 2016. You can use this direct link to order. Thank you and we look forward to your business!

2015-2016 Mustang Bracket | Craig's Custom Mustang Brackets

Respectfully,

Craig Broussard
757-636-2445
Just got the bracket in the mail yesterday. Now I just need the car to be delivered.
 

·
Registered
Joined
·
41 Posts
Discussion Starter · #9 ·
Yes, it is from Craig. Like Dave said, there is a supplied wipe that you prep the valence with. It attaches underneath so even with the bracket removed, the bracket mount is barely visible. The bracket itself is of a very good quality.
 

·
Registered
Joined
·
232 Posts
Thanks for the info guys. I have the bracket but am waiting for it to warm up before I put it on (says 70 degrees or so). I just got a bit hesitant when I saw I had to bond it to the valance....
 

·
Registered
Joined
·
2 Posts
I bought one on ebay and installed in temps below 50F. Super high quality and the adhesive seems like it will hold forever. You can't see the mount unless you know where to look. I highly recommend.
 

·
Registered
Joined
·
142 Posts
I also purchased this and when I was bonding the plate to the bumper, I noticed that the bumper was predrilled for a mounting bracket. The holes were covered by the vinyl stripe but looking at the strip from a low angle enabled me to clearly see the tro holes. Has anyone else noticed this?
 

·
Registered
Joined
·
757 Posts
I also purchased this and when I was bonding the plate to the bumper, I noticed that the bumper was predrilled for a mounting bracket. The holes were covered by the vinyl stripe but looking at the strip from a low angle enabled me to clearly see the tro holes. Has anyone else noticed this?
Bob, those should only be indentations not actual holes...unless yours were drilled prior to installing stripes...
 

·
Registered
Joined
·
757 Posts
That makes sense that they're just indentations to serve as guides if you elect to drill. Glad my dealer chose to leave the choice up to me.
Well said Sir, back in 2007 when I ordered the GT 500, I made sure everyone knew NOT to drill the front bumper for the license bracket...unfortunately, they all went to lunch and the detail guy took it upon himself to drill and attach the front license plate bracket. My buddy who was the dealership GM was horrified and offered to cancel the deal. Unfortunately, it was their last allocation for that year and I had a killer deal on it so I accepted it anyways...but huge disappointment for sure!!

Needless to say, my current dealer knows to not install the front splitter or the license plate bracket...
 
1 - 20 of 32 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top