GT350.org banner

1 - 5 of 5 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
Greetings everyone. So I just purchased my new to me 2017 GT350 and noticed that my drivers side mirror doesn't seem to have an power to it. Both turn signal and adjustment is not functional. I could bring to the dealer to look at but it's raining and the car is clean and I'm bored so digging into the issue myself. I can't seem to find documentation anywhere on what fuses the mirrors use. I really don't want to have to pull a door panel to go check out connectors so hoping just dealing with a fuse problem. Can't be switch given the fact the turn signal isn't working either. Anyway thanks in advance for the help!
 

·
Registered
Joined
·
206 Posts
I am at work so I can't check this but on the 2009 Mustangs, you can change that mirror in 5 minutes--I know as I tore one off backing the car off the trailer. Check to see if you can get to it easily.
May not be as bad as you thought to check the plug and if it is in, you can check for voltage
 

·
Registered
Joined
·
8 Posts
Discussion Starter #4
I am at work so I can't check this but on the 2009 Mustangs, you can change that mirror in 5 minutes--I know as I tore one off backing the car off the trailer. Check to see if you can get to it easily.
May not be as bad as you thought to check the plug and if it is in, you can check for voltage
Supposedly you gently pry with a screwdriver between mirror and the gimble that it's attached to behind it and it pops off. Sounds like a bunch of let the dealer break little plastic tabs fun to me. I'll bring it by them to check it out. Now on to removing taillights and side markers so I can get them spray tinted :)
 

·
Registered
Joined
·
206 Posts
KenF,
Most of the time those parts come off real easy but you are right that you can break things. they do have special plastic pry devices to remove almost anything in the interior of the car. Be very careful if you should decide to try with a screwdriver. Then the other issue, the car is under warranty, let them do the work Good luck Let us know what the problem was
 
1 - 5 of 5 Posts
Top