Mustang GT350 Forums banner
1 - 8 of 8 Posts

·
Registered
Joined
·
757 Posts
Discussion Starter · #1 ·
JLT Coil covers and strut tower covers!! These things are nice, top quality paint for sure and EXACT match!! Nice job Justin and Lisa!!


Motor vehicle Automotive design Toy Automotive tire Bumper

Font Material property Rectangle Electric blue Electronic device
 

·
Registered
Joined
·
757 Posts
Discussion Starter · #3 ·
Dang now I want some coil covers in Triple Yellow !!
Voodu, they are nice, if you get the shock tower covers as well, be sure and relocate your washer line where it comes across the underside of the hood right above the passenger side shock tower. I didn't notice it but when I closed the hood the line was pinched between the hood and JLT shock tower cover and it left a mark in the JLT cover. I've since repositioned the line so it doesn't pinch anymore.
 

·
Registered
Joined
·
33 Posts
do those covers just pop on or do you have to remove the valve covers
 

·
Registered
Joined
·
757 Posts
Discussion Starter · #6 ·
do those covers just pop on or do you have to remove the valve covers
Only thing you have to disconnect are the 2 EGR lines and they unclip ver easily. Helps to remove the Oil Fill cap for the passenger side but they just plug into rubber grommets.
 

·
Registered
Joined
·
144 Posts
Any concerns with heat dissipation with these covers over the engine?

They look very good, but I'm guessing they are a bad idea.
 

·
Registered
Joined
·
757 Posts
Discussion Starter · #8 ·
Any concerns with heat dissipation with these covers over the engine?

They look very good, but I'm guessing they are a bad idea.
I don't think anyone has had any issues, especially since they are the OEM covers (that came on the car) just painted to match...
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top